You only need to loosen the pinch-bolt at the top on either side fork tube and the centre nut on yoke.No need to go near stem unless bearings are worn or done.How do you remove the Steering stem lock-nut and washer from 06 GSXR 600? I need to install handle bars.?
use a steering stem socket...
the proper tool comes on my bike's factory tool kit under the seat, you might be as lucky...
and kyle, most modern sport bikes have clip on handle bars...for someone who's going into the MSF training, you don't know so much about sport bikes...How do you remove the Steering stem lock-nut and washer from 06 GSXR 600? I need to install handle bars.?
The top nut and washer do not have to be removed to install handlebars.
The left %26amp; right handlebars are mounted to the fork tubes.
If you just want to loosen the nut, loosen it with a socket and ratchet as you would with any fastener.
ok i was about to say use channel locks, but then i realized you don't need to use that for handlebars..... o.0
that's to take the tripple clamp out...
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment